|
Hi all,
fixed it! David nailed it, thank you David!
DIN cable was the culprit after all!
I opened up the DC101 supply case while all connected and
measured 15V and -18V going out , via the DIN jack.
But only getting 15v on one set of the 4 pins, the -18v was missing at the field end of the cable.
A quick continuity check end to end of the DIN cable revealed broken wires
in the socket at one end. The end that flexes the most while in use!
The reason why the other rail had gone up to -18v and not -15 is, I am assuming it wasn't under load.
Measured it once a quick re-solder was done....15v and -15v rails!
FWIW guys, the native driver set kindly linked by David work now.
EZCAP 3.36 working fine now on a Win 10 64bit OS.
Steve
|