|
Thanks for the reply,
Yes i figured tis might be the case, was trying to see if it was possible or not.
I see there is a usb port on the hand controller that is the same as the one on the AZ-EQ6 mount, but this runs through the hand controller, so not sure if that would work.
The hand control port on the mount is a 6 pin RJ-12, where the one on the AZ-EQ6 is a 8 pin RJ-45 going by the book.
The idea was to connect straight into the 6 pin RJ-12 and to the pc.
Will keep searching for some information, but i guess the biggest thing is the way the two mounts are setup, AZ-EQ6 pointing directly at the scp, where the goto mount are setup facing south but tube sitting level.
Will be an interesting project if i can get it all to work.
|