Quote:
Originally Posted by Andyhcmc
Sorry to confuse,,, The dongle when plugged into the mount connects to phone/tablet but when app started and hitting connect is says device not found.
So I was asking if there is anyway to rest it via computer?
|
out of the box it is configured for Acess Point mode.
1. Turn on wifi on phone tablet, Connect to wifi network like SynScan_WiFi_####, where #### are unique numbers for that module.
Then open synscan app on phone/tablet and press connect. From the pdf
https://www.manualslib.com/manual/17...y...%20More%20
I quote
Quote
3. Configure the AdapterIn your SynScan app, tap Settings > WiFi Setting.• Check "Modify Access Point" to- Enable/Disable the Access Point Mode.- Change the SSID(Name of the access point)- Add or remove password for accessing the adapter's Wi-Fi access point.• Check "Modify Station" to- Enable/Disable the Station Mode- Enter the SSID of the Wi-Fi access point (router) to which the adapter will connect.- Enter the password for the designated Wi-Fi access point (router).- Enter a static IP.Tap "Apply" button to confirm setting. You might need to restart the mount and/orre-connect to the correct Wi-Fi network on your smartphone.Important: In most case, users should use either "Access Point Mode" or "StationMode", DONOT enable both of them.
End Quote
You should only need to do the above if you wish to change the AP name or switch to station mode.