Thread: [NOT REQUIRED] Visual back, SCT 1.25"
View Single Post
  #1  
Old 13-01-2021, 11:43 AM
38degsouth's Avatar
38degsouth (Dean)
Now at 32degsouth

38degsouth is offline 		 
Join Date: Jul 2013
Location: Perth (Como), Australia
Posts: 154
Visual back, SCT 1.25"
Hi all,

I'm seeking a visual back for my SCT. There are a few specific requirements though..

1.25" holder with brass compression ring (or rotolock or similar) & an overall profile of 40mm or less. A 1.25" dust cap would be nice, but not critical.

This is required for holding a hyperstar counterweight in place, the low profile is so that the 'scope will fit in its case with the adapter in-situ.

Thanks for looking.

Regards, Dean