Hey Bojan,
Not quite. Here's a link to mine. Although many of your suggestions are still relevant.
http://www.iceinspace.com.au/forum/s...d.php?t=176305
Quote:
Originally Posted by bojan
If I understood correctly, you have something like I have?
I solved my problem (slippage) with higher pressure between wheels (stronger springs). You can try with heavier load? Or pre-load with springs? Less grease?
dip shaft in epoxy glue and sprinkle it with sand from sand-paper? Wrap sand-paper around shaft?
Use shaft from old printer, they are treated with grit to increase friction with paper.
I would advise against knurling, as un-evenness may cause problems with tracking, and knurls are usually very coarse. |