Quote:
Originally Posted by xelasnave
Hi Martin
I was able to venture out to the scope and mount and plugged in my old cable..set the baud rate and I could control the mount via Ramos but not the little box in Sharpcap and I had no success in connecting to Stellarium as I was without your notes...anyways a small step forward as the cable works and my previous installations seem ok...I will have another go later or tomorrow. You would not believe it..the scope has only been set up for a week or so and already a wasp made a nest on the clamps..sadly I removed it an destroyed the potential life of a few creatures...
Alex
|
One deceased wasp won’t destroy the species , luck you didn’t get stung they are nasty , worse than bees
Glad the cable works , that’s a start
Yes you need your procedure notes as there’s specific details you need to follow
I had some trouble last night with Stellarium and EQMOD, I had them installed as normal but PHD2 was caused EQMOD to launch a second time and then disconnected the mount. So I shut down everything , set Stellarium, EQMOD APT and PHD2 to “Run as Administrator “ in properties and it fixed the issue as I run each program up manually and sequentially. I don’t let programs launch other programs like most folk do. Hope you get it all up and running when your out next
Good luck
Martin