|
Nick,
Here’s my Registax 6 basic user guide below
Cheers
Martin
Registax 6 - Wavelet Sharpening and Processing
1/ Open Registax 6 on Laptop or PC
2/ Press “Select” and load your 16bit stacked image from Autostakkert 3
3/ Click on “Wavelet” tab and image will load into Registax 6 window view
LEFT SIDE CONTROL PANEL
4/ Select “Linear” and make sure “Step Increment” is set to 0.Leave “ Initial Layer” to 1 or 2
5/ “Automatic” check box is used if you want to see your changes instantly rather than use “Do All” tab and wait.”Automatic” is best left unchecked and use “Do All” tab.
6/ Leave “Hold Wavelet Setting” unchecked
7/ Leave “Used Link Wavelets” unchecked as this is not required
8/ Denoise and Sharpen feature has 6 sliders numbered Layer 1 to Layer 6. Layer 1 is for the small features in the image and Layer 2 upwards are for the larger features in the image. An image with poor detail or poor resolution due to seeing conditions etc... or high SNR will require say Layer 2 or 3 and upwards to achieve any result. An image with good detail will only require say Layer 1,2 and 3 to achieve a result. In any case adjust sliders to produce the desired result
9/ “Available Schemes” leave this section blank as it controls the sliders behave
RIGHT SIDE CONTROL PANEL
1/ “Histogram” button usually left as default
2/ “RGB Balance” button click “Auto Balance” tab
3/ “RGB Align” button is used to align the colour across the whole object. Once opened press the “Show Area” button and drag the green box around the object then press the “Estimate” tab. The RGB align is then processed automatically
4/ “Gamma” button is used to brighten or darken various parts of the object depending on the way or direction you bend the curve on the graph
5/ “De noise and De ringing” button is used to reduce shadows or fuzz in parts of the image
6/ All remaining buttons perform various colour control and sharpening to the image , so try them.
7/ Brightness and Contrast sliders control the amount of brightness, contrast across the object
8/ Remember to press “Do All” after each adjustment or function
9/ When final image has been processed to desired taste press “Save Image” tab and save image as a tiff or jpeg file to a folder in your nominated location on Laptop or PC.
|