Thanks again. Will get some lubricant on it.
as usual I fix one problem only to uncover the next. The filter doesn’t fit ito the flattener it’s about 1mm too small.
Now I can’t figure out where to mount the filter. I’ve tried pretty much every join in the image train and none of them work. It will screw in to the end of my spacers but this covers the threads that join the flattener.
My last hope is that it will go in between the two spacers (they are currently in the freezer because they are also stuck together
). Actually these are stuck much worse than the flattener I’ve just pulled them out of the freezer and they still won’t unscrew.
Any other suggestions as to where the filter should go? I don’t have a filter wheel.
The small space in between the spacers (shown in this pic) is where I’m hoping it fits.