|
Belt and Timing Pulley Robofocus Setup
Dear All
Im wading into a project involving automating focus using a robofocus unit for a canon eos lens.
The shaft diameter of the robofocus is 6.3mm however im finding that many of the timing pulley bore diameters are either 6mm or 8mm
When choosing the belt ive measured an appropriate timing belt length to be about 450mm - all good.
However im having trouble matching the tooth of the canon lens teeth, the timing belt and then the pulley.
Anyway, if theres any feedback/ experience in selecting the appropriate parts feedback would be greatly appreciated
With thanks in advance
Rob Hamlin
|