View Single Post
  #7  
Old 12-08-2018, 08:46 PM
Dbroz (Daniel)
Registered User

Dbroz is offline
 
Join Date: Aug 2018
Location: Melbourne
Posts: 49
Thanks Matt for the warm welcome,

I only posted this question about an hour ago and already got a few replies, what your saying makes perfect sense. I still think I need to re make the rings though, they are only 40mm wide not allowing enough room to move the focuser board in and out if needed. Plus there isn’t much room to tighten the thum screws for the pole connector I made. If I re make the rings what do you think the best ID size would be?

And again thank you all for your feedback

Daniel
Reply With Quote