Quote:
Originally Posted by bojan
Something around power regulator... better picture may be helpful  |
Thanks and good point about the image Bojan, I have attached a better one!
Quote:
Originally Posted by Russj
G'day Stu,
I had a problem with my NEQ6 I spoke to Tasco the distributors in Sydney they sent me a new board under warranty.
NZ distributor for SW should have new boards might be worth ringing them.
Russ
|
Thanks, Russ, I will try to find the NZ distributor but it's probably the same people. My EQ6 is out of warranty sadly
Quote:
Originally Posted by AndrewJ
Gday Stu
It's an inductor that has blown up.
You could try cleaning the area around it and then just shorting the gap, but it might have been caused by one of the nearby capacitors going short.
Andrew
|
Awesome Andrew, I will give it a clean and have a go at a repair. I have nothing to lose as a new one is going to cost me NZ$220+. Attached a new picture too.
Stu