|
Drilling counterweight?
I have a question that may appear a bit simple -but here goes.
My EQ6 mount has a special counterweight shaft that was machined up to be 24mm diameter. My vernier measures it at 23.97mm
Now I want to buy a smaller EQ3 counterweight (19mm hole) and then drill it out.
Q. If I order a 24mm drill, can I be assured that it will drill out slightly larger than 24mm, or will it end up being an interference fit and I will struggle to get the weight on the shaft? If so I will have to order a 25mm drill.
many thanks
|