|
Hi Shawn,
First I measured the diameter of the threads where my accessories would not fit direct to each other. Used a digital caliper to do this. There was only 2 different diameters 41.98mm = T-Thread and 50.75mm = SCT. Then all you have to stipulate is if it is to be male or female thread to fit. I worked out that I would need 2 of TF to SCTM (F and M= female and male) and 1 of SCTF to TM adapters. There're not any garantees that I will get focus, but I had to try something. Hope I can inform you before the end of this comming week on that.
|