|
Anyone handy with a soldering iron?!
To avoid future problems with NEQ6 power supply failure, I'd like to fit an immobilised, short (3-5 cm) male + female (standard 2.1 mm tip, centre positive) power connection lead to the 12V input socket on the mount.
This would stop flexing affecting the connection to the main circuit board (which I just replaced for $230!).
If anyone can do this, I'm happy to pay for parts and generously for your time.
It only involves bog-standard bits and soldering!
Dean
Last edited by deanm; 27-04-2017 at 07:31 PM.
Reason: Spulling!
|