Looks like I've fried my motor board in the mount... My attempt at an EQDirect cable was not very successful and nothing works now.
Mount powers up, red light etc, but comes up with the message 'No response from both axis's'
Anyone know where I can get a replacement or have it fixed. I don't think there is much support over here. Synscan Pro EQ6
Visual check shows no damage on the board but there was a bit of a nasty sounding noise when I think it happened. I was hoping there wasa couple of fuse links or something but can't find anything.
Out of action, should have just stuck to the hand control, it was all working so well.
And of course now the sky is clear ...
