Quote:
Originally Posted by Dennis
That’s interesting behaviour and not something I have seen before. I think I’m on Software Version V1.3.2Beta1.
What software version were you using when the anomaly occurred?
Cheers
Dennis
|
hello Dennis, i am on the latest non-beta version as downloaded via the QHYccd polemaster website. Can't check at work so will report back tonight.
Further to this, it only happened as i was getting close to overlapping. it was just fine when they were further apart. even if i went very slowly on the AZ knobs it would lose lock at the same spot every time. so then maybe it wasnt the camera settings and something else. i did spend quite a bit of time on each step, maybe i was messing around with adjustments too long (like rotating 30 degrees and stuff).
i ended up restarting everything and trying again and it was OK but it would occaisionally twitch like it wanted to lose lock still.