|
Robofocus/FocusMax issue
Hi. I have read with interest your note in the forum going back many moons, it was the one about your focus point ****fing back with every run.
I have the same problem, being trying to make the Focusmax work now for something I am almost at a stage to throw the towel. I have a TaK106ed, with the Robofocus.
Last night I did a manual focus to around 2, and started the V Curve routing. Having 35mm of drawtube extension with 4400 steps, put on 'half width' column, the first run I managed to get a v shape, but after that the V curve moved to the left, and the focus step started to move down.
So, I question if you do not mind, did you managed to solve your problem.
If you did do you mind sharing your solution.
KR & Thanks
Charles
|