|
Did you run Pempro with the new PEC uploaded to the PMX? You should see a reduction in PE when you do this and its part of Pempro procedure.
If you setup your mount in Pempro using the mount wizard your curve should be correct. But it may need to be inverted if its making things worse ie its pushing when it should not be etc.
Try inverting the curve or better do the mount calibration wizard and then do a fresh PEC.
Also there is no need to go near that whole page for uploading the pec curve from Pempro to PMX. You setup the mount in Pempro and select PMX and when you create the PEC curve it should come up with an option to create Paramount PEC curve. When you click on that it copies to clipboard and its ready to go into Sky X.
You open TCS, open PEC, clear existing curve then paste which pastes the new curve that was copied to the Clipboard then save to mount once you see it.
My PME curve is somewhat like a bumpy sine wave with the peak of the sine wave on the left side of the TCS PEC display of the curve.
I just did a fresh one last night so this is all fresh in my mind.
Greg.
|