Quote:
Originally Posted by Starkler
I had a play with it this evening started off with a 6 star model.
I calculated for IE only and got a result of +6.8+-2
After fitting that model I did a run of 12 stars and got the following results:
RMS =5.3 (was 8.8)
PSD =7.1 (was 10.4)
CA =107.5+-36.5
IE =8.1+-1.7
NPAE =-81.6+-31.6
|
Good to see you performed a TPAS run.
It is also nice to know the RAW RMS of the data. You can always find the
RAW RMS value by spinning the DIAL clockwise in the REVIEW DATA submenu
until you reach the entry that says END OF DATA on the top line of the
display. The bottom line of the display will show either the RAW RMS or
FIT RMS. You can alternate between the two values by pressing ENTER,
spinning the DIAL until it shows the type of RMS you are interested in
examining and then pressing ENTER again.
The 'WAS' values you see when you perform a COMPUTE are not always the
same as the RAW RMS. The 'WAS' values are what you would get if the
current 'IN USE' model is applied to the data. The RMS and PSD values
you see are those that you would get if you were to apply the model
as defined in DEFINE MODEL. Therefore the 'WAS" values are a convenient
way of seeing at a glance whether the RMS and PSD drops when you
expermient with alternative models in DEFINE MODEL.
If you currently have a 'null' model IN USE, then the 'WAS' values will
be equivalent to the RAW values.
Quote:
Originally Posted by Starkler
I tried adding terms ECES and ECEC but they seemed to degrade the PSD, so I fitted the above model. A test run touring globulars seemed to work fairly well so I went back to compute and selected "USE NOW AND SAVE".
After powering off and back on again, I went back into "SET ERROR VALUES" and upon looking for the values calculated from the prior session they were all zeros 
|
Just be sure that when you "USE NOW AND SAVE", that you keep pressing ENTER
until you see the COMPUTE submenu appear again. The reason for this is that
the values are only actually put in USE and SAVED when you press ENTER on
the final term. If you press EXIT at any time, the USE NOW and SAVE will be
cancelled. If you power off the unit prior to dealing with the last term, likewise
no terms will be saved.
I can't envisage any other scenario that would result in the values
not being saved except the above. but let me know if you experience any
further difficulty.
Also be sure to check out the Argo Navis User's Group on Yahoo
for further tips from time to time.
http://groups.yahoo.com/group/argo_navis_dtc
Best Regards
Gary Kopff
Managing Director
Wildcard Innovations Pty. Ltd.
20 Kilmory Place, Mount Kuring-Gai
NSW. 2080. Australia
Phone +61-2-9457-9049
Fax +61-2-9457-9593
sales@wildcard-innovations.com.au
http://www.wildcard-innovations.com.au