|
Ok I've finally got some more work done on this.
I routed the channels to enable me to bend the composite panel a hair to short on one side which caused it to split when I tightened it all up. I might have to find some capping to go over the corners to tidy it up a bit.
Besides the cosmetic issues, it seems to be ok so far. Only thing left after the cladding is fully fixed it to figure out what I'm going to use for the azimuth alignment bolts to push against. Might make a quick trip out to Bunnings and grab some aluminium.
Not entirely sure if the adhesive will work to hold the cladding on; says it works on anodized aluminium and concrete, so should be ok, but I guess we'll see.
|