Rowland my next question has to do with the copper clips on the side of the frame and sensor boards that hold the two boards together. I can't work out how to get the finger in there when the clips are in place? What did you do with them?. One of your photos from your other thread:
http://www.synergous.com/flatpress/f...ion-part-1.pdf
seems to indicate that you just glued the whole thing together with silicon, is that correct?
I could shorten the finger to get the right hand side frame clip on the chip but that means reduced surface area on the chip. It's impossible to get the clip to fit over the finger to hold it and the chip board (well maybe if I bend it flat and cut it alittle it might fit).
If you look at Gary Honis' instructions here (Step 21 on this page)
http://dslrmodifications.com/rebelmod450d3.html
, the photo (Step 21) which is attached, he is holding the sensor assembly and you can clearly see the copper clips on each side.