|
Sounds good Glen. I might follow your lead on the insulation. It gets tight, with just room enough in places, particularly if you want to locate a sensor between/underneath camera parts.
Attached CF dimensions. from the original dxf file. Note: Think about adding 5mm or so as indicated. While the CF fits more room is advisable to access the various ports along side the CF.
Glen. Please let me know if you find anomolies with the CF dimensions - suggestions for improvement. While, I am sure that it will fit without a hitch, please verify before cutting and bending.
Last edited by rcheshire; 17-03-2015 at 01:18 PM.
|