|
Glen. I will upload a file with dimemsions. I use plastic screws to reduce conduction to the sensor frame - I do all I can to isolate the CF. In theory, the screws will break under load, rather than twist things out of shape, if the camera is dropped. The finger must be grounded if using a TEC system. I'm not sure the Canon screws are long enough? The top of the cold finger sits about 3.5mm higher than the EMI shield screw down points. Personal preference? 2mm deep colletts are needed under the cold finger to support the CF.
Prior to filling the cavities created by the sensor pins to PCB gap, isolate the edges of the CF from the pins with strips of plastic - or some other means.
|