View Single Post
  #51  
Old 25-12-2014, 10:01 PM
traveller's Avatar
traveller (Bo)
Not enough time and money

traveller is offline
 
Join Date: Aug 2011
Location: Melbourne
Posts: 2,133
Thanks Rowland,
So just to summarise, there is no advantage in having a large conductive surface to the cold side of the TEC, as it would only decrease the efficiency of the module.
Therefore, a copper strip size of a camera base plate (similar to your drawing below) would be sufficient and more effective than a large copper sheet covering the lower half of camera body (which was what I planned).
I will also need a lower current than the one rated on the TEC and a slightly larger fan over the hot surface to increase the efficiency.
Thanks,
Bo
Reply With Quote