|
You don't indicate how far outside the spot the laser is? With the typical play and pressure variance in a compression ring eyepiece holder with three screws, it is not unusual for the laser spot to wander within the center area and onto the outer edge of the ring. Try reinserting several times and tightening to see how it changes position. The average position of the laser may indicate it is close to the center. Of course there is also a small risk that the secondary may also not have been spotted accurately!
The moonlite focuser has got collimation ability, however I would be tempted to let sleeping dogs lie. Many GSO RC owners have purchased a tip tilt ring to align the mechanical axis with the optical axis for the purposes of collimation.
Note there is a lot of stiction on the secondary adjustment screws when first making an adjustment. Only make minute changes to screw position and observe changes in the Tak scope
Ted
|