Thread: RORO shed
View Single Post
  #56  
Old 16-10-2014, 07:27 AM
ZeroID's Avatar
ZeroID (Brent)
Lost in Space ....

ZeroID is offline
 
Join Date: May 2010
Location: Auckland, NZ
Posts: 4,949
In the shed could the pier be part or integral to a partition wall ? I created a darkroom in a garage many years ago. If you pick the right position it could give better usage to the shed, Office maybe, or warm rom with PCs etc.
Floor plan with measurements required. Photos as well, inside, outside. Still quite an expensive option all the same, floor joists, beams, floor surface, pier materials, wiring, opening roof modifications.
Based on your earlier posting about budgetary restrictions, this is not a cheap option.
But dreams are free

My tinshed Ob only cost about $400 plus about $500 to modify it. Cheap chinese kitset garden shed reinforced with 6 x 1 fencing timber where required, corners, top rails. Ply and timber split roof and beleive it or not some big pallets from work supported to make the floor. Free.
Then work recarpeted with carpet tiles and I collected the leftovers, new to do the floor, again free. And the big drain pipe pier of course.
Most used tool, my battery drill and a lot of spire screws holding it all together.
Reply With Quote