Quote:
Originally Posted by Paul Haese
Roger undo the motor from the focusor and move the motor so it racks out. Make sure you do it for 20 seconds or so. Put the motor back on the focusor and see where the position count is from there. It should give you enough room.
You can also do a reset and power up the robofocus whilst holding down the in button and rack that all the way in and then all the way out to reset the limits. See the manual on that.
|
Quote:
Originally Posted by alocky
Hi Roger - there's a procedure for doing this in the robofocus software - I seem to recall holding down one button when switching the unit on...
|
Thanks both.
I searched the manual this morning for various terms but didn't find the single button reset, that sounds like exactly what I need.
I am hopeful that having done what I did this morning (read previous comment) that for now the problem is solved, but if it's not this button down while booting up sounds like the ticket
I'll take another look in the manual for that too.