View Single Post
  #25  
Old 15-07-2014, 01:53 PM
ZeroID's Avatar
ZeroID (Brent)
Lost in Space ....

ZeroID is offline
 
Join Date: May 2010
Location: Auckland, NZ
Posts: 4,949
Quote:
Originally Posted by Octane View Post
Thank you, Russell and Richard. Good to know!

Can you link to what type of screws you used as replacements?

If I go this route, I'll need to put it up on 50cm blocks, as my gear stands 2m tall. Unless I park it on its side. My preference is the counterweight down position, though.

H
A 2 high block wall will give you enough height and also stop water ingress under the 'shed' walls. I had some water coming in as Richard did in the bottom channels so just got a tube of expanding foam filler and filled the channels in on the outside.
Incorporate a raised step at the door as well to keep water at bay.
Reply With Quote