[jjz (Joe)]

Being a keen woodworker I thought I better make my own observing chair, no plans were used but its based on a design by Peter Sayers I found online

The chair is 1060mm high, 380mm wide and weighs in at about 8kgs.

The seating Height ranges from 350-800mm.

The top notch is for seat removal and the rear legs are doubled up for stability, the wood used was mainly hardwood scrap I had lying around, but I used 22mm dowels for the seat supports.

I'll probably use this one for a while and them make a better/lighter version in the future when I figure out what features I do/dont like.

Thanks for looking
Joez