Hey guys,
Just purchased Robofocus for my FSQ and having a few problems installing it.
I have the shaft installed on to the focuser knob and I'm now trying to fit the bracket.
Do I remove the two hex screws shown in the photo below?
They seem to be either very tight or glued in, and I'm worried they might be part of the collimation or something. (However there are sets of tiny grub screws either side that seem to be collimation screws, I just dont want to stuff it up)
Should I just put a bit more force into it and not worry?
Should the bracket go somewhere else?
Or is there some technique to get these out without using brute force?
Thanks guys
http://i1329.photobucket.com/albums/...ps2a4f68e6.jpg