[Astroman (Andrew Wall)]

Hi all,

I require the assistance of someone with the proper equipment, that knows how to bore a couple of holes into some timing pulley's I got. The Aluminium Timing pulleys will be put onto my Focuser so I can put a stepper motor onto it and automate it. The larger of the Pulleys requires either a bore to go on the 10:1 side of the focuser or the other side (haven't quite decided yet), and the other (smaller one) will require a 5mm bore for a stepper motor. Both pulleys will then need to be drilled and tapped with a grub screw of about 2-3mm. If anyone is able to help out with this project please PM me, or reply to this thread. I would like someone in Adelaide to this please.

If you know someone or an engineering mob that could help out that would be good too..

Thanks in advance.

Picture added.