Yo all,
Find some more time to continue the build by creating a storage section for all my electronics and stuff.
First image - shows the split base idea that allow the whole section to be removed with all the telescope parts in place. Screws located on the base are design to remove half and slide it out for any changes. I may have to do this as I have placed it 90 degrees out. So I will complete the build to test the idea and rotate the whole thing 90 degrees once complete.
The idea is semi permanent not designed to be changed continually but on occasion including when rental tenancy requires us to vacate.
our lease is due in a couple of months.
Third and fourth image is the frame used to house all the electronics etc. The four section on each corner will house draw slides and drawers so they can be slid out to display all the gear if needed.
Final image is the cabinet I picked up at auction. The 2 door version pick up for $0.45c each. The drawer runners will be removed and re-installed in the unit, far cheaper than buying new runners and I recycled.
Made an awful error on the build, I should have built it outside the base place then fitted it , instead I tried to install it piece by piece while installed. Although nothing is actually wrong, it took a hell of a long arduous process to get the build. If I measured then installed it would have served me better.
More to come later, before the money runs out.