|
Got all setup to test my PE after installing the belts and it's been so long since I used EQMOD and a handset to control the scope that I couldn't hear the motors when I set it off on the fastest rate as the mount is so quiet now. Tried to use PEMPRO with the ZWO camera but no go, so I will have to use the DSI if tomorrow night holds up. Had to reset the DEC as I hadn't adjusted it properly but now both axis have no backlash at all which is nice. Will post here when I have some data, but I should state that the belt mod is actually a doddle to do after doing the hyper tune.
Allan
|