|
Ok all done, tested running just like a store brought one..or two ..or three! Martian has his already.
Peter4059 and Bram I'll need you post address and emails ..by PM so I can send them, probably Monday, I need to sort packing etc.
I tested them all with my stepper system, all functions: Temp measure and compensation; manual control and manual control change; USB connection and connect via ASCOM ok; check all functions via computer; and Runs my ML stepper just fine.
I also did current draw checks and these were the same as original, spot on. So I'm happy to release them into the wild.
So, I'll send the: PCBs; PCB LED looms; cases; manual control and temp probes (both already made up). You will need to cut and drill and file the case for the PCB to fit in...honestly I am time short atm so I'll leave that part to you both but I'll send vai email a drill/cut CAD drawing with measurements on this.
I'll include all hardware necessary to secure the PCBs but as said leave the case cutting to you both. I'll also send some small mounting notes and details.
Finally...done!
|