|
Hi Peter,
I use append on sync and I have tried removing an alignment set after building up about 10 sync points and then starting again in the same quadrant, but it doesn't seem to help much.
I notice my mount shoots off at almost full speed when I give it a goto and if I have any slop as you say, maybe it is exacerbating the issue? I don't know if you can set the slew speeds in EQAscom too reduce the top speed of the slews?
Most of the time I need to "plate solve" by recognising the star patterns on the CCD view to figure out where I actually am in relation to the intended target, and then slew in the direction I think I need to go. It's starting to annoy me, especially on faint galaxies etc....
Chris
|