Ok this one has completely got me stumped.
I'm running a fitpc2 now with XP 32bit SP3 installed.
I have G11 L4, 1.05.
Trying 1.0.53 gemini.net driver
When I go to configure telepscope, it never saves my applied time offset of +8. Even if I set it, then Ok, and connect it still does not apply thiswhen it connects. Im dumbfounded why this is happening.
I've tried nearly everything. reset cmos. etc..
Everytime it connects it wont apply the correct timezone.
Now the kicker is.. I connected to my W7 64bit laptop that use to drive everything which has 1.0.53 gemini.net. It connects, prompts me to cold start and loads the correct timezone. And I can verify it by checking the Gemini status.
Now I disconnected; then plugged rs232 cable back to fitpc2. Opened Gemini.net and unticked 'Set Gemini Time on connect' and 'Set Gemini Site on connect.
It connects appears to send data to the mount, and when I check status the timezone is +0 and local time is -8 ?
see attached screenshots. Heeelp
