Quote:
Originally Posted by Logieberra
After reading this
I'd head straight to the plungers on RA and adjust them. They are the simplest of mechanical adjustments on the MX.
From the SB document, Replacing the Paramount MX Worm Block Assembly:
Centering the Worm Block
To ensure the worm teeth are as centered as can be on the gear teeth, ensure the 1⁄4-20’s are tightened while lifting up and engaging worm block. You will need two 3/16 allen wrenches.
1. Ensure 1⁄4-20 screws on rotate axis are loose.
|
Logan,
Thanks very much for this!!
I've read the entire Worm Block Assembly document. Just to be completely certain (as the document doesn't identify the plungers) are they the 2 vertical screws on either side of the cam stop pin? And the 1/4-20 are the 2 hex nuts with the two allen wrenchs shown in the photo you attached?
Peter