|
Roger,
From your website I gather that the roof motorization, manual buttons AND limit switches are already installed ?
If so, to connect this or a similar board wire as shown.
You may be better off getting a board that can monitor inputs as well as relay outputs. This will allow you to monitor that the roof is actually open, closed or somewhere in the middle. (Power outages or other system crashes may cause some ambiguity of where the roof is).
Limit switches are important in that it automatically stops the motor when the roof is either fully open or closed. Definitely required for remote operation !.
Another point is whether the mount has to be parked for safe closing without expensive collisions.
If the motor is not already installed and operating, then this will require a bit more discussion.
Neil.
|