EQ6 Problems.

[bloodhound31]

OK, last time I took my EQ6 Pro mount out bush, I did an alignment on it, using a 2 star alignment. This isn't the first time it has asked for star number three, then failed when I said no. Even when I said yes, it pointed in completely the wrong direction! I'm talking pointing at the ground and stuff.

So, How do I completely reset it and start again from scratch?

Baz.

[Grimmeister]

Hi Bloodhound,

If it's anything like the EQ3 Synscan hand controller I believe there is an option in the Utility menu to do a full factory reset. This should be what your looking for.

I had a similar issue with my hand controller (not quite pointing at the ground but well off target:confused2:) and for the life of me could not work out the issue so did the reset and all came back normal again.:thumbsup:

I think it may be the PAE settings getting a bit stuffed up but I am not sure. As soon as I can power it up I will find the exact menu location for you.

Hope this helps?

Cheers

Anthony

[Grimmeister]

Hi Bloodhound,

Just powered the hand controller on, it is in the following location:
setup menu
Factory Setting (Enter)
1) Yes 2) No

Once you press 1 it will flash up clearing data (or something like that and go back to the factory settings menu.

P.S. I assume you haven't accidentally set the position ot time wrong? Such ???'??" W and ??'??" N in the Enter Location Menu? Just to rule out the simple things??

Cheers

Anthony

[bloodhound31]

Thanks Anthony. I'll give that a go.

Baz.