sheeny
11-09-2010, 06:39 PM
Celestron C8 SGT, bought new in 2005. Just not being used any more, so I want to see it go to someone who will use it (and give me some cash;)).
Extras include:
Motofocus remote focusser
Baader solar filter
Dew Heater
dew shield
Piggy back bracket
Finderscope dew heaters (home made)
Celestron Anti-vibration pads
Celestron RS-232 Cable (#93920). This connects computer to hand controller for computer control of the mount via ASCOM and software of your choice.
Tripod has some superficial marks from transport and handling. Power cable has been modified to replace a damaged 12V plug, reduce voltage drop (heavier cable) and add a connector to allow it to fit through the conduit in the floor of my observatory. Hand controller is not the new flash upgradable one. Includes original short dovetail plate for use with a scope with tube rings.
$1300 for the lot (SOLD), pick up at Oberon, or I'm prepared to drive up to 2 hours to meet/deliver, or I can bring with me to IISAC'10 for hand over. I don't have the original boxes so freighting is probably out of the question.
I also have a PST that's just not being used either any more. SN 100300. It did have the dreaded objective rust, but it went back to Coronado and was fixed under warranty. Its a great little scope for getting into Ha solar observing/imaging. It is fitted out in a small red tool box for transport storage and protection, which I'll include if you pick up the scope, but if you want the scope mailed I'll put the scope back in the original box and packaging for safe transport (i.e I'll keep the toolbox, but they are not expensive). Standard 20mm Kellner EP included. $530 plus postage!;) The only reason I'm not using it is I have the ED80 setup in the obs and I have an SM40 and B1200 blocking filter to use on that.
Sorry there's no photos yet... I'm writing this so I have to take some to post tomorrow!:P
Al.
Extras include:
Motofocus remote focusser
Baader solar filter
Dew Heater
dew shield
Piggy back bracket
Finderscope dew heaters (home made)
Celestron Anti-vibration pads
Celestron RS-232 Cable (#93920). This connects computer to hand controller for computer control of the mount via ASCOM and software of your choice.
Tripod has some superficial marks from transport and handling. Power cable has been modified to replace a damaged 12V plug, reduce voltage drop (heavier cable) and add a connector to allow it to fit through the conduit in the floor of my observatory. Hand controller is not the new flash upgradable one. Includes original short dovetail plate for use with a scope with tube rings.
$1300 for the lot (SOLD), pick up at Oberon, or I'm prepared to drive up to 2 hours to meet/deliver, or I can bring with me to IISAC'10 for hand over. I don't have the original boxes so freighting is probably out of the question.
I also have a PST that's just not being used either any more. SN 100300. It did have the dreaded objective rust, but it went back to Coronado and was fixed under warranty. Its a great little scope for getting into Ha solar observing/imaging. It is fitted out in a small red tool box for transport storage and protection, which I'll include if you pick up the scope, but if you want the scope mailed I'll put the scope back in the original box and packaging for safe transport (i.e I'll keep the toolbox, but they are not expensive). Standard 20mm Kellner EP included. $530 plus postage!;) The only reason I'm not using it is I have the ED80 setup in the obs and I have an SM40 and B1200 blocking filter to use on that.
Sorry there's no photos yet... I'm writing this so I have to take some to post tomorrow!:P
Al.