leon
30-04-2007, 12:14 PM
Hi Guys
I was thinking of buying some adjustable Tube Rings and Mounting Plate for the Takahashi, but thought they were a bit pricey, so decided to make them instead,
The rings are cut from a 140mm dia steel pipe, and the plate is 8mm plate steel 90mm wide x 240mm long, all drilled, and threaded to fit nicely on the double clamshell tube holders on the G11.
Cost $4.40 for the plate steel, and nothing for the pipe, i had lying around, plus about $14.00 for extra bolts, and rubber stoppers.
So all up, under $20.00. plus my time, but that is free, and fun. ;)
Cheers Leon :thumbsup:
I was thinking of buying some adjustable Tube Rings and Mounting Plate for the Takahashi, but thought they were a bit pricey, so decided to make them instead,
The rings are cut from a 140mm dia steel pipe, and the plate is 8mm plate steel 90mm wide x 240mm long, all drilled, and threaded to fit nicely on the double clamshell tube holders on the G11.
Cost $4.40 for the plate steel, and nothing for the pipe, i had lying around, plus about $14.00 for extra bolts, and rubber stoppers.
So all up, under $20.00. plus my time, but that is free, and fun. ;)
Cheers Leon :thumbsup: