38degsouth
13-01-2021, 11:43 AM
Hi all,
I'm seeking a visual back for my SCT. There are a few specific requirements though..
1.25" holder with brass compression ring (or rotolock or similar) & an overall profile of 40mm or less. A 1.25" dust cap would be nice, but not critical.
This is required for holding a hyperstar counterweight in place, the low profile is so that the 'scope will fit in its case with the adapter in-situ.
Thanks for looking.
Regards, Dean
I'm seeking a visual back for my SCT. There are a few specific requirements though..
1.25" holder with brass compression ring (or rotolock or similar) & an overall profile of 40mm or less. A 1.25" dust cap would be nice, but not critical.
This is required for holding a hyperstar counterweight in place, the low profile is so that the 'scope will fit in its case with the adapter in-situ.
Thanks for looking.
Regards, Dean