Budget Bench Drill

[Outcast]

Wasn't sure where to put this so, decided General Chat was the safest:

I'm considering a bench drill for a timber project; I need to drill some 25mm diameter holes through 19mm Iron Bark...

Now, I've done a test drill on some ironbark & my cordless does the job but, not as precisely as I would like..

I do have other uses for the Bench drill so, it's not just for a one off project but, don't want to spend a fortune either...

The spectrum so far ranges from an Ozito at $115 to a Bosch at $399; there are a number in between: Ryobi, Renegade, Detroit, etc...

I need it to be fairly precise, otherwise I'll just do it by hand... does anyone have any experience (good/bad/indifferent) with a budget Bench drill that they could share with me please?

Cheers

[raymo]

All the budget pedestal drills will do what you need. I have had my $99 GMC
for about 12 yrs, still going strong. I have several Ozito hand tools, damn good value for money.
raymo

[PCH]

I agree with Raymo. I’ve had plenty of ozito stuff and the 5 year replacement warranty is hard to beat. With the drill press, quality drill bits will make the difference as I’m sure you know. I’m about to nip out and grab an ozito multi tool skin only for a miserly $69! Amazing value :D

[multiweb]

+1 I picked one up from total tool in Sydney for just under $100. They're good enough. You'll probably need to pull it apart, deburr and regrease where needed, align and probably square the motor and belts. But that's about it. They're simple devices. It's not a mill.

[Gary47]

I well remember getting my backside thoroughly kicked for destroying a very expensive saw blade trying to rip saw a piece of well cured Ironbark. Melted the teeth and left scorch marks in the wood which rendered it useless.

[billdan]

I remember reading in one of the metalwork forums, buy a drill press with a rotatable work-plate. Your future self will thank you for this.

[raymo]

If you find that a pedestal drill with a rotating work plate is too expensive,
buy one with the conventional swivelling plate, and get one of the small
vices made to clamp onto the work plate. That arrangement will be o.k. for
anything you need to do.
raymo

[multiweb]

:lol: Indeed. :thumbsup:

[Crater101]

I have an old Ryobi that's done a lot of the work over the years and just still keeps going.


My only word of caution would be to make sure that whatever one you select, the chuck will actually hold the size of drill bit that you want to use. Not all of them go to 25mm (mine goes to 22mm).

[Outcast]

Thankyou, all...I have a number of Ozito products, good bang for buck I agree.






You over estimate my mechanical ability...:rofl:





Cheers, I'll keep both of these tips in mind



I'll be using either auger or spade bit with narrow shank but, I will indeed consider chuck size in my deliberations, cheers

[Huey]

Whatever you decide to get, make sure you have a key-less chuck to go with it. It makes life a lot easier especially if you have to change drill bit a couple of times.

Huey

[dikman]

Regarding chucks, most will take either 12mm or 16mm bits. If you want to use larger drill bits (excluding spade bits) then they usually come as Morse taper bits that replace the chuck. I've had a largish drill press for probably 40 years and I don't understand how anyone can manage without one.:D

[Crater101]

This is true, but mine is like me - getting on in years - and the chuck can't be replaced easily. Not at my level of mechanical ability, anyway...