View Full Version here: : QHY5L-II Mono Guide cable
04Stefan07
08-01-2016, 06:15 PM
I have a case full of my cables all mixed and have confused my QHY5L-II guide cable with a few other RJ10 cables and can't remember which cable was the correct one.
Anyone here with the same camera can provide a picture of the correct RJ10 cable?
Cheers,
Stefan.
Seymore
08-01-2016, 08:39 PM
It should be a standard RJ11/RJ12 Cable with 6 pins, make sure there are six coloured cables in there and they are the same order at the other end and you are good to go.
Cheers
Seymore
Merlin66
08-01-2016, 08:57 PM
http://www.store.shoestringastronomy.com/guide_port_cables.pdf
Check your cables against the above ST-4 reference.
04Stefan07
08-01-2016, 10:56 PM
Ok think I found it but the colours are different.
With the clip facing me it goes from left
Yellow, blue, red, green, black, orange.
Seymore
09-01-2016, 12:59 AM
As long as the colours are the same on both sides it will be fine.
Cheers
Seymore
Atmos
09-01-2016, 07:21 AM
Worst comes to worst there is always trial and error method :)
04Stefan07
09-01-2016, 12:43 PM
Beautiful got it.
Wasn't sure cause I didn't want to blow anything up!
Cheers.
jenchris
09-01-2016, 12:55 PM
now a piece of masking tape with the words "Guide cable" - applied to the wire will obviate any repeat performance.
tileys
12-01-2016, 11:24 AM
I always put mine back in the tin - it's easy to find - it's the really curly one in the tin ;)
I will however be filing this thread away in case...
04Stefan07
12-01-2016, 04:39 PM
Yep I had other cables labelled except this one!! :confused2:
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.