ICEINSPACE
Member Login
Most Read Articles
Moon Phase
CURRENT MOON Waxing Gibbous
71%
The Sun Now




Skateboard Wheel Dob Mount
Submitted: Tuesday, 4th July 2006 by Geoff Liddicoat

Here are a few details of the DOB mount I made out of light gauge steel tube, and some round.

The materials cost me a total of about $30 unpainted.

You need to be handy with steel fabricating and have either a MIG welder or an oxy set. I made the frame along the same dimensions as a 10 inch dob timber mount.

The lower frame for the adjustable feet and center swivel is made of  20mm X 50 mm X 1mm thick tube welded to a center piece of 40 mm pipe 50 mm long.  The center swivel is 18 mm rod 120 mm long with a hole in the end to take a large split pin. I used skateboard wheels for the feet.

The upper removable scope holder frame is of  15 mm square, 1 mm thick. I made the half round bearing suface for the Alt scope movement of 15mm X 3mm Flat steel and stuck on Teflon, so this part is no different from a normal DOB mount. The bottom of this frame has a piece of 40 mm round 3mm thick, 100 mm long with two old bearings fixed one each end. This allows the top section to be dropped onto the 18 mm rod, and held with a large split pin, made to remove easily. Any reasonable old bearings can be used  and a piece of rod to suite, as long as it is thick enough.

I mounted skateboard wheels onto 25 X 5 mm flat steel bent to suit the circumference of the wheel track, and this is screwed onto the frame with 6mm screws and nuts. I slotted the holes to enable fine adjustment of the wheels for running on the circular 19mm MDF  board which has a  laminex  finish. The MDF board is screwed to the bottom 3 legs with packers for adjustment. I marked 0 to 360 degrees on the board with a pointer, mostly for show.

I made a simple brake on the bottom of the 40 mm tube to prevent the scope from slewing on uneven ground. Only slight pressure is needed for this.

On the sides of the frame are the 12 volt battery cradle and the heated box for the eyepieces.
I stuck on some felt and some neoprene tube where the scope was likely to touch.

The mount works well and is about three quarters of the weight of a timber mount. It comes apart easily for fitting into the boot of the car.

It is a lot of work for these advantages, but I like to experiment!

DOB01.jpgDOB02.jpg

Click to Enlarge
The complete mount

Click to Enlarge
Closeup
DOB03.jpgDOB04.jpg

Click to Enlarge
Comes apart for travel

Click to Enlarge
With the OTA on top!
Article by Geoff Liddicoat (Geoff). Discuss this article on the IceInSpace Forum.
Advertisement
Testar
Advertisement
Bintel
Advertisement
ICEINSPACE
AUSTRALIAN AMATEUR ASTRONOMY
Copyright © 2004-2024 ICEINSPACE.
All rights reserved.