I'm keen on a few ADM bits and pieces, most desperately an AZ GTI replacement saddle. Wondering if anyone knows of places that might be likely to be holding stock?
Side note, anyone have any thoughts on ADM vs Geoptik for saddles and general quality?
ADM are well made solid products I buy direct even after freight cost and current exchange rate still a bit cheaper than you can as buy for here, if you don't mind the delay in receiving them due to COVID
ADM are well made solid products I buy direct even after freight cost and current exchange rate still a bit cheaper than you can as buy for here, if you don't mind the delay in receiving them due to COVID
Cheers Trevor. Have you had anything sent over in the past few months?
J-P,
I use both the ADM and Geoptic saddles on my HEQ5 and NEQ6 mounts.
I'm impressed with the quality of both. I haven't had any problems using them over the past ten years.
It took ADM 3 months to get my puck from them. I sent several emails but didn't get a single reply. I know it wasn't their fault it was late, since USPS is going through some SERIOUS problems at the moment. But it would have been nice to at least get an email back!
Tell me the hole spacing and I can tell you if I have anything compatible. I think I do.
Hi Lewis,
The mount first needs a puck to generate enough standoff for the dovetail mount to turn without fouling the mount body. I'm not at all sure of that hole spacing, from there I think the options for mounts is wide open. Do you mean that you might have a puck to suit? Or, perhaps I can find the hole pattern on the current puck without ripping off the cap on mine
Tony, I emailed ADM when I started this thread, asking about UPS of fedex possibilities for international deliveries, no reply yet (its early days yet)... perhaps that means they're working on it!