FocusMaxV4 High HFD
Hi,
I am using FocusMax4 with a feathertouch focusser on a EDGE HD 9.25. While iit will focus for me, usually it fails a number of times before completing 1st light wizard.
Anyway, when I look at the log, the HFS's are very high, around 10 to 18 on a successful 1st light. So even after getting focus I can normally acheive a better focus just by adjusting with the hand controller.
I have attached a successful 1st light log.
Any suggestions as to why it is so high?
I have also attached a photo of Saturn in another post, where I adjusted after focus by a few hundred steps on the hand control.
Following is the tail of the log
22:57:57 382968, 10.35, 382238, 555, 221, 371609, 5281, 1
22:57:58 382968, 10.86, 382238, 559, 220, 314604, 3424, 1
22:57:59 382968, 11.93, 382238, 561, 217, 347321, 3296, 1
22:58:00 382968, 09.96, 382238, 560, 218, 338368, 4528, 1
22:58:00 Focus position: 382238
22:58:00 Moving to focus position: 382238
22:58:02 Taking images at focus position
22:58:02 Adjusting exposure based on flux target
22:58:02 Setting exposure: 0.12
22:58:04 Pos., HFD, X, Y, Flux, Pixel, Count
22:58:04 382238, 15.11, 568, 214, 322395, 2203, 1
22:58:05 382238, 15.20, 560, 216, 359941, 2953, 1
22:58:06 382238, 15.40, 564, 214, 327494, 2062, 1
22:58:07 382238, 16.55, 564, 216, 347973, 1796, 1
22:58:07 382238, 18.73, 565, 216, 300806, 1184, 1
22:58:07 Position = 382238 Avg HFD = 16.20
22:58:07 Temperature: 12.1 Filter: No filter wheel detected (slot 1)
22:58:07 ** AutoFocus Completed **
22:58:07 Focus time: 25 sec
22:58:08 Auto VCurve Sequence complete
22:58:08 First Light Sequence completed
Cheers
Paul
|