Selling an EQ6 Pro mount with a few modifications.
Custom made altitude adjustment knobs makes adjustment much easier than the standard levers and they are finished in a nice anodized Celestron orange.
The original weight bar has been replaced with a longer sturdier bar that allows you to use much less weight to balance the scope. Less weight better tracking.
The original weight bar on an EQ6 is 285mm long the custom made bar on this mount is 465mm long and 25mm in diameter. It is easily removed for transport, it screws in.
Overall the mount is in good condition, working perfectly but cosmetically it has a few paint chips and some of the bolts are a little tarnished.
I have the original box for transport.
Comes with 2x Counterweights
Synscan hand controller
240 - 12 volt Power Supply
$750 PM me if you are interested. I can deliver in the Brisbane area or post at cost.
Last edited by ubique; 15-02-2020 at 10:58 PM.
Reason: sold
Selling an EQ6 Pro mount with a few modifications.
Custom made altitude adjustment knobs makes adjustment much easier than the standard levers and they are finished in a nice anodized Celestron orange.
The original weight bar has been replaced with a longer sturdier bar that allows you to use much less weight to balance the scope. Less weight better tracking.
The original weight bar on an EQ6 is 285mm long the custom made bar on this mount is 465mm long and 25mm in diameter. It is easily removed for transport, it screws in.
Overall the mount is in good condition, working perfectly but cosmetically it has a few paint chips and some of the bolts are a little tarnished.
I have the original box for transport.
Comes with 2x Counterweights
Synscan hand controller
240 - 12 volt Power Supply
$750 PM me if you are interested. I can deliver in the Brisbane area or post at cost.