#1  
Old 08-12-2018, 05:53 PM
multiweb's Avatar
multiweb (Marc)
ze frogginator

multiweb is offline
 
Join Date: Oct 2007
Location: Sydney
Posts: 22,060
G11 Backlash

I've been plagued with guiding issues for a few months now. Not a major issue at F/5 with the FSQ and its 3asp image scale but defintely with the C11 at 3m and even more with my CN-212. It's just unforgiving and lately it got worse. So I had to do something about it and pull my fingers.

I went through checking everything I could think of: the worm meshing, the end blocks, the bearings, changed gearboxes a couple of time, checked the couplings between the gearboxes and the worm to no avail.

Eventually I had to narrow it down to the coupling. Logically that was the only place that could have that much play. Problem with the new losmandy worm blocks is you can't see jack squat when they're mounted. The old system had a removable cover so you could inspect and tweak things with the worm mounted and meshed to the gear.

So this arvo I took the DEC worm block out and well... check the video below. I made a little red paint dot on the gearbox shaft as a reference marker. See the delay between the shaft rotation and the coupling starting to rotate when I apply pressure on it in the second half of the footage.

Reply With Quote
  #2  
Old 08-12-2018, 09:20 PM
Peter Ward's Avatar
Peter Ward
Galaxy hitchhiking guide

Peter Ward is offline
 
Join Date: Dec 2007
Location: The Shire
Posts: 8,090
Humm...I'd have stripped the mount down, cleaned and re-lubricated all the bearings (the literally bind in very old grease). Same with the RA gear and worm (clean and re-lube) .

The coupling does have some designed-in play, but a drop of Loctite on the shaft would ensure the worm and motor shafts are not slipping.
Reply With Quote
  #3  
Old 08-12-2018, 09:41 PM
multiweb's Avatar
multiweb (Marc)
ze frogginator

multiweb is offline
 
Join Date: Oct 2007
Location: Sydney
Posts: 22,060
I do that once a year. Never liked those couplings. They're a bit too short and there's not enough overlap for the clamps to properly hold the shafts. I ordered two new sets from huco. They're longer. That should do the job.
Reply With Quote
  #4  
Old 08-12-2018, 09:54 PM
Peter Ward's Avatar
Peter Ward
Galaxy hitchhiking guide

Peter Ward is offline
 
Join Date: Dec 2007
Location: The Shire
Posts: 8,090
Quote:
Originally Posted by multiweb View Post
I do that once a year. Never liked those couplings. They're a bit too short and there's not enough overlap for the clamps to properly hold the shafts. I ordered two new sets from huco. They're longer. That should do the job.
Fair 'nuff
Reply With Quote
Reply

Bookmarks

Thread Tools
Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +10. The time is now 12:35 AM.

Powered by vBulletin Version 3.8.7 | Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Advertisement
Testar
Advertisement
Bintel
Advertisement