Go Back   IceInSpace > Equipment > ATM and DIY Projects

Reply
 
Thread Tools Rate Thread
  #101  
Old 09-07-2019, 02:53 AM
Corpze (Daniel)
Registered User

Corpze is offline
 
Join Date: May 2019
Location: Sweden
Posts: 5
Hi again.
I recieved two new boards (4ch irf540) but both of them puts out 12v regardless if the respective channel is activated by the arduino or not (the led on the 4ch mosfet board is only shining when the arduino output is activated by the code ( as it should be)

But even if the output from the arduino is 0% and the LED on the mosfet board is dark, it is 12v to the heater band and it gets really hot.

My connections is correct on the low-level side, as the LED is on or off when the arduino activates the output.

The 12v side is connected as 12v+ in and ground (shared ground with the arduino)

The outputs are connected 12v+ and ground from each channel to a RCA connector with same ground as the casing (and arduino)

I just can't seem to understand why the mosfet is always on?
Reply With Quote
Reply

Bookmarks

Thread Tools
Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +10. The time is now 09:56 PM.

Powered by vBulletin Version 3.8.7 | Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Advertisement
SkyWatcher Australia
Advertisement
OzScopes Authorised Dealer
Advertisement
Bintel
Advertisement
Meade Australia
Advertisement
Lunatico Astronomical
Advertisement
NexDome Observatories
Advertisement
Celestron Australia
Advertisement
Astronomy and Electronics Centre
Advertisement